I’ve come across something that causes some concern.
Choose Standard Bags
Choose Layflat
Click Material & Additives
Check Anti-block
Check High Slip
Change Material to Non Slip.
You get a message saying if you continue we will need to reset the Anti-Block additive. Do you wish to continue?
However, saying yes this leaves High Slip checked as well. I’m sure this is because we never go through the High Slip Validation because onceJudy’s program hits an error it returns the error.
How do we want to handle this situation?
- A long message explaining everything that is wrong
- multiple messages saying A is invalid, then B is invalid, then C is invalid, etc.
- 1 message only telling them about part of the problem. then reset everything needed to make the new selection (Material choice in this case) valid